Concept Guide

ipv6 radius
ipv6 radius {nas-ip6 <ipv6-addr>|source-interface {loopback|vlan <vlan> <ip6addr>}
Description
This command configures global parameters for configured IPv6 RADIUS servers.
Syntax
Parameter Description
nas-ip6
A global NAS IPv6 address to send in RADIUS packets. This configuration
supercedes the server-specific NAS IPv6 configured with the aaa
authentication-server radius command.
source-inter
face
Interface for all outgoing RADIUS packets. The IPv6 address of the specified
interface is included in the IP header of RADIUS packets. The interface can be
one of the following:
loopback
The loopback interface.
vlan
The specified VLAN.
Usage Guidelines
This command configures global IPv6 RADIUS server parameters. If the aaa authentication-server radius
command configures a server-specific NAS IPv6 address, the server-specific IPv6 address is used instead.
Example
The following command configures a global NAS IPv6 address sent in RADIUS packets:
(host) (config) #ipv6 radius nas-ip6 2001:470:20::2
Command History
This command was introduced in ArubaOS 6.3.
Command Information
Platform License Command Mode
Available on all platforms Available in the base operating system. Config mode on master and local
controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ipv6 radius | 555