Concept Guide

lacp timeout
lacp timeout {long | short}
Description
Configure the timeout period for the LACP session.
Syntax
Parameter Description
long
Enter the keyword long to set the LACP session to 90 seconds. This is the
default.
short
Enter the keyword short to set the LACP session to 3 seconds.
Usage Guidelines
The timeout value is the amount of time that a port-channel interface waits for a LACPDU (Link Aggregation
Control Protocol data unit) from the remote system before terminating the LACP session. The default time out
value is 90 seconds (long).
Related Commands
Command Description
lacp group Enable LACP and configure on the interface
show lacp View the LACP configuration status
show lacp sys-id View the LACP system ID information
show interface port-channel View information on a specified port channel interface
Command History
Release Modification
ArubaOS 3.4.1 Command introduced
Command Information
Platforms Licensing Command Mode
All Platforms Base operating system Configuration Interface Mode (config-if)
for Master and Local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide lacp timeout | 563