Concept Guide

mac-address-table
mac-address-table static <macaddr> {fastethernet|gigabitethernet} <slot>/<module>/<port> vlan
<vlan>
Description
This command adds a static entry to the MAC address table.
Syntax
Parameter Description Range
<macaddr>
Media Access Control (MAC) address, in the format
xx:xx:xx:xx:xx:xx.
—
<slot>/<module>/<port>
Any command that references a Fast Ethernet or Gigabit
Ethernet interface requires that you specify the
corresponding port on the controller in the format
<slot>/<module>/<port>.
—
vlan
ID number of the VLAN. 1-4094
Usage Guidelines
The MAC address table is used to forward traffic between ports on the controller. The table includes addresses
learned by the controller. This command allows you to manually enter static addresses that are bound to
specific ports and VLANs.
Example
The following command configures a MAC address table entry:
(host) (config) #mac-address-table static 00:0b:86:f0:05:60 fastethernet 1/12 vlan 22
Command History
Available in ArubaOS 3.0
Command Information
Platform License Command Mode
Available on all
platforms
Available in the base
operating system
Config mode on master and local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide mac-address-table | 613