Concept Guide
Example
The following command enables packet capturing for debugging a wireless WEP station doing VPN. This
example uses the following parameters and values:
l Station up/down: sysmsg opcode 30
l WEP key plumbing: sysmsg opcode 29
l DHCP: sysmsg opcode 90
l IKE: UDP port 500 and 4500
l Layer 2 Tunneling Protocol (L2TP): UDP port 1701
(host) #packet-capturesysmsg30,29,90
(host) #packet-capture udp500,4500,1701,1812,1645
Command History
This command was introduced in ArubaOS 2.3.
Release Modification
ArubaOS 2.3 Command introduced
ArubaOS 6.3
The following parameters were added:
l controlpath
l copy-to-flash
l datapath ipsec and datapath wifi-client
l destination
l reset-pcap
l no parameter has replaced disable
The following parameters were moved under the controlpath parameter:
l interprocess
l other
l sysmsg
l tcp
l udp
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable mode on master and local
controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide packet-capture | 645