Concept Guide

661| perf-test Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description
ip6-addr <ip6-addr>
IPv6 address of the AP.
TCP
Run Iperf tests using the TCP protocol.
UDP
Run Iperf tests using the UDP protocol.
bandwidth <value>
Rate at which the Iperf test data should be sent, in bits/sec. The default value
is 1 Mbit/sec. This parameter supports the suffixes K (to represent Kbits/sec)
and M (to represent Mbits/sec.)
duration
Number of seconds for which the test runs. The supported range is 10-120
seconds, and the default value is 10 seconds.
parallel
Number of parallel clients threads to run.
window
TCP window size. This parameter supports the suffixes K (to represent Kbit-
s/sec) and M (to represent Mbits/sec.)
port open|close
Use this command under the guidance of Dell technical support to open
port 5001 to allow Iperf throughput tests between the controller and
the AP.
Usage Guidelines
The report generated by an Iperf throughput test can be viewed by issuing the command .
Related Commands
Command Description
show perf-test
reports
Use this command under the guidance of Delltechnical support to view the results of an
Iperf throughput test launched from the controller.
Command History
Introduced in ArubaOS 6.3.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable mode on master or local
controllers