Concept Guide

807| show aaa authentication via connection-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Allow client to auto-upgrade Enabled
VIA tunneled networks N/A
Enable split tunneling Disabled
VIA Client WLAN profiles N/A
Allow client side logging Enabled
VIA IKE V2 Policy Default
VIA IKE Policy Default
Use Windows Credentials Enabled
Enable IKEv2 Disabled
Use Suite B Cryptography Disabled
IKEv2 Authentication method user-cert
VIA IPSec V2 Crypto Map default-ikev2-dynamicmap/10000
VIA IPSec Crypto Map default-dynamicmap/10000
Allow user to save passwords Enabled
Enable Supplicant Disabled
Enable FIPS Module Disabled
Auto-launch Supplicant Disabled
Lockdown All Settings Disabled
Domain Suffix in VIA Authentication Disabled
Enable Controllers Load Balance Disabled
Enable Domain Pre-connect Enabled
VIA Banner Message Reappearance Timeout(minutes) 60
VIA Client Network Mask 255.255.255.255
Validate Server Certificate Enabled
VIA Client DNS Suffix List N/A
VIA max session timeout 1440 min
VIA Logon Script N/A
VIA Logoff Script N/A
VIA Support E-Mail Address N/A
Maximum reconnection attempts 3
VIA external download URL N/A
Allow user to disconnect VIA Enabled
Content Security Gateway URL N/A
Comma seperated list of HTTP ports to be inspected
(apart from default port 80) N/A
Enable Content Security Services Disabled
Keep VIA window minimized Disabled
Block traffic until VPN tunnel is up Disabled
Block traffic rules N/A
The output of this command includes the following parameters:
Parameter Description
VIA servers Displays the following information about the VIA server:
l Controller Hostname/IP Address: This is the public IP address or the DNS
hostname of the VIA controller. Users will connect to remote server using
this IP address or the hostname.
l Controller Internal IP Address: This is the IP address of any of the VLAN
interface IP addresses belongs to this controller.
l Controller Description: This is a human-readable description of the
controller.
Client Auto-Login Enable or disable VIA client to auto login and establish a secure connection to
the controller.
Default: Enabled