Concept Guide

show ap arm virtual-beacon-report
show ap arm virtual-beacon-report
ap-name <name>
ip-addr <ipaddr>
ip6-addr <ip6-addr>
phy-type 80211a|80211b|80211g
Description
If the client match feature is enabled, the output of this command displays the virtual beacon report for an
APwith a specific IP or MAC address.
Syntax
Parameter Description
ap-name <name>
Name of an AP for which you want to view a virtual beacon report.
ip-addr <ipaddr>
IPv4 address of an AP for which you want to view a virtual beacon report.
ip6-addr <ipv6addr>
IPv6 address of an AP for which you want to view a virtual beacon report.
phy-type
Display virtual beacon report data for an AP radio with one of the following
phy types:
l 80211a
l 80211b
l 80211g
Usage Guidelines
If the client match feature is enabled, the controller sends APs a list of clients that should not be allowed to
associate to that AP.
Example
(host) #show ap arm virtual-beacon-report ap-name 1263-ac
Interface:wifi0
Rx VBR Reports:683
Client MAC:24:77:03:cf:fa:5c
Dual band:Yes
Active Voice:No
Steerable:Yes
Dual network capable:No
Current Association:6c:f3:7f:e7:5a:b0
Virtual Beacon Report
---------------------
AP Channel Signal (dBm) EIRP Assoc
-- ------- ------------ ---- -----
9c:1c:12:fd:d2:10 60 -76 12
9c:1c:12:fd:d2:00 1 -66 12
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap arm virtual-beacon-report | 987