Concept Guide

Figure 100 L3 Mobility Window
4. Select Enabled from the Home agent load balancing drop-down list. By default, home agent load
balancing is disabled.
5. Click New in the Virtual Controller IP Addresses section, add the IP address of a VC that is part of the
mobility domain, and click OK.
6. Repeat Steps 2 to 5, to add the IP addresses of all VC that form the L3 mobility domain.
7. Click New in the Subnets section and specify the following:
a. Enter the client subnet in the IP address text box.
b. Enter the mask in the Subnet mask text box.
c. Enter the VLAN ID of the home network in the VLAN ID text box.
d. Enter the home VC IP address for this subnet in the Virtual controller IP text box.
8. Click OK.
In the CLI
To configure a mobility domain:
(Instant AP)(config)# l3-mobility
(Instant AP)(L3-mobility)# home-agent-load-balancing
(Instant AP)(L3-mobility)# virtual-controller <IP-address>
(Instant AP)(L3-mobility)# subnet <IP-address> <subnet-mask> <VLAN-ID> <virtual-controller-IP-
address>
(Instant AP)(L3-mobility)# end
(Instant AP)# commit apply
Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Mobility and Client Management | 340