Concept Guide

Configuration Steps CLI Commands UI Procedure
(Instant AP)(SSID Profile "wireless-ssid")# auth-
survivability
7. Create access rule for
wired and wireless
authentication.
For wired profile:
(Instant AP)(config)# wlan access-rule wired-port
(Instant AP)(Access Rule "wired-port")# rule any
any match any any any permit
For WLAN SSID employee roles:
(Instant AP)(config)# wlan access-rule wireless-
ssid
(Instant AP)(Access Rule "wireless-ssid")# rule any
any match any any any permit
See
Configuring
ACL Rules for
Network
Services
NOTE: Ensure that you execute the commit apply command in the Instant CLI before saving the configuration and
propagating changes across the W-IAP cluster.
Table 87: W-IAP Configuration for Scenario—GRE: Single Datacenter Deployment with No Redundancy
W-IAP-Connected Switch Configuration
Client VLANs defined in this example must be opened on the upstream switches in multiple W-IAP
deployments, as client traffic from the slave to the master is tagged with the client VLAN.
Datacenter Configuration
For information on controller configuration, see Configuring a Controller for IAP-VPN Operations on page 243.
The following GRE configuration is required on the controller:
(host)(config)# interface tunnel <Number>
(host)(config-tunnel)# description <Description>
(host)(config-tunnel)# tunnel mode gre <ID>
(host)(config-tunnel)# tunnel source <controller-IP>
(host)(config-tunnel)# tunnel destination <AP-IP>
(host)(config-tunnel)# trusted
(host)(config-tunnel)# tunnel vlan <allowed-VLAN>
Glossary
The following table lists the terms and their definitions used in this document.
Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide IAP-VPN Deployment Scenarios | 411