Concept Guide
(Instant AP)(SSID Profile <name>)# max-clients-threshold <number-of-clients>
(Instant AP)(SSID Profile <name>)# end
(Instant AP)# commit apply
Temporal Diversity and Maximum Retries using CLI
Starting from Instant 6.5.0.0-4.3.0.0, when clients are not responding to 802.11 packets with the temporal-
diversity parameter disabled, which is the default setting, W-IAPs can attempt only hardware retries. But if
this parameter is enabled when the clients are not responding to 802.11 packets, W-IAPs can perform two
hardware retries. When the hardware retry attempts fail, W-IAPs can perform software retries.
The max-retries parameter indicates the maximum number of attempts the W-IAP performs when clients are
not responding to 802.11 packets. By default, the W-IAP attempts a maximum of eight retries when clients are
not responding to 802.11 packets.
The following example shows the configuration of temporal-diversity and max-retries in a WLAN SSID
profile:
(Instant AP) (config) # wlan ssid-profile Name
(Instant AP) (SSID Profile "Name") # temporal-diversity
(Instant AP) (SSID Profile "Name") # max-retries 3
(Instant AP) (SSID Profile "Name") # end
(Instant AP) # commit apply
Configuring VLAN Settings for a WLAN SSID Profile
If you are creating a new SSID profile, complete the WLANSettings procedure before configuring the VLAN. For
more information, see Configuring WLAN Settings for an SSID Profile on page 78.
You can configure VLAN settings for an SSID profile using the Instant UI or the CLI.
In the Instant UI
To configure VLAN settings for an SSID:
1. On the VLAN tab of the New WLAN window, perform the following steps. The following figure displays the
contents of the VLAN tab.
Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Wireless Network Profiles | 83