Users Guide

591 | Access Points Dell Networking W-Series ArubaOS 6.4.x| User Guide
1. Navigate to the Configuration > Advanced Services> All Profiles page.
2. In the Profiles list, select AP to expand the AP profile menu.
3. Select AP Wired Port Profile to display a list of existing wired port profiles
4. Select the AP wired port profile you want to support 802.az. The Ethernet interface link profile currently
associated with the port profile appears below the port profile in the Profiles list.
5. Click the Ethernet interface link profile currently associated with the AP wired port profile you want to
modify. The settings for the Ethernet interface link profile appear in the Profile Details window.
6. Click the Ethernet interface link profile drop-down list at the top of the Profile Details window, and
select a new Ethernet interface link profile.
7. Click Apply to save your changes.
In the CLI
To enable support for 803.az EEE, access the command-line interface in config mode and issue the following
command:
ap enet-link-profile <profile> dot3az
Associate a new Ethernet Interface link profile with an AP wired port profile using the following command:
ap wired-port-profile <profile>
enet-link-profile <profile>
AP LEDs
AP LEDs can be configured in two modes: normal and off. In normal mode, the AP LEDs will light as expected.
When the mode is set to off, all of the LEDs on the affected APs are disabled.
In the WebUI
An AP system profile’s LED operating mode affects LEDS on all APs using that profile.
This option is available on the W-AP90 Series and W-AP105 access points.
1. Navigate to the Configuration > Advanced Services> All Profiles page.
2. Select the AP tab and then select the AP system profiles tab.
3. Select the AP system profile you want to modify.
4. Locate the LED operating mode parameter.
5. From the drop-down list, select off.
6. Click Apply.
In the CLI
Use the ap system-profile command to disable LEDs for all APs using a particular system profile.
(host) (config)# ap system-profile <profile-name> led-mode {normal | off}
Use the ap-leds command to make the LEDs on a defined set of APs either blink or display in the currently
configured LED operating mode. Note that if the LED operating mode defined in the AP’s system profile is set
to “off”, then the normal parameter in the ap-leds command will disable the LEDs. If the LED operating mode
in the AP system profile is set to “normal” then the normal parameter in this command will allow the LEDs light
as usual.
(host) (config)# ap-leds {all | ap-group <ap-group> | ap-name <ap-name> | ip-addr <ip address>
| wired-mac <mac address>} {global blink|normal}|{local blink|normal}