Users Guide

Summary
Table Name
Basic View Information Advanced View Information
Wired Ports
Status
l Port: port numbers of the wired
ports on the AP
l Status: current status of each port
(Connected, LinkDown or Disabled).
The advanced view of the Wired Access
Ports table displays the following data:
l Port: port numbers of the wired ports
on the AP
l Status: current status of each port
(Connected, LinkDown or Disabled)
l MAC Address: MAC address of the
wired port
l Speed: speed of the link
l Duplex Type: duplex mode of the link,
full or half
l Forwarding mode: forwarding mode
for the port: Bridge, Tunnel or Split
Tunnel
l Users: fumber of users accessing each
port
l Rx Packets: number of packets
received on the port
l Tx packets: number of packets
transmitted via the port
Wireless SSIDs l SSID: Name of the SSID.
l Status: SSID Status (up, down, or
disabled).
l Band: Radio band available on the
SSID.
l SSID: name of the SSID
l Status: SSID Status (up, down, or
disabled).
l Band: radio band available on the SSID
l Channel: channel used on the radio
band
l BSSID: BSSID of the wireless SSID
l Forwarding Mode: forwarding mode
used by the Wireless SSID (Bridge,
Tunnel or Split-Tunnel)
l EIRP: equivalent Isotropic Radiated
Power, in dBm
l Noise floor: residual background noise
detected by an AP. Noise seen by an AP
is reported as -dBm Therefore, a noise
floor of -100 dBm is smaller (lower)
than a noise floor of -50 dBm.
l Users: number of users on the radio
band
l Rx Packets: number of packets
received on the BSSID
l Tx packets: number of packets
Table 145: RAP Console Summary Tab Information
Dell Networking W-Series ArubaOS 6.4.x | User Guide Remote Access Points |
730