Users Guide

819 | Spectrum Analysis Dell Networking W-Series ArubaOS 6.4.x| User Guide
Viewing Spectrum Analysis Data
You can use the command-line interface to view spectrum analysis data from any spectrum monitor, even if
that spectrum monitor is currently sending data to another spectrum monitor client’s WebUI.
Table 169 shows the commands that display spectrum analysis data in the CLI interface.
Command Description
show ap spectrum ap-list
Shows spectrum data seen by an access point that has been
converted to a spectrum monitor.
show ap spectrum channel-metrics
Shows channel utilization information for a 802.11a or
802.11g radio band, as seen by a spectrum monitor
show ap spectrum channel-summary
Displays a summary of the 802.11a or 802.11g channels
seen by a spectrum monitor.
show ap spectrum client-list
Shows details for Wi-Fi clients seen by a specified spectrum
monitor.
show ap spectrum debug
Sub-commands under this command save spectrum
analysis channel information to a file on the controller.
show ap spectrum device-duty-cycle
Shows the current duty cycle for devices on all channels
being monitored by the spectrum monitor radio.
show ap spectrum device-history
Displays spectrum analysis history for non-interfering
devices.
show ap spectrum device-list
Shows summary table and channel information for non-Wi-
Fi devices currently seen by the spectrum monitor.
show ap spectrum device-log
Shows a time log of add and delete events for non-Wi-Fi
devices.
show ap spectrum device-summary
Shows the numbers of Wi-Fi and non-Wi-Fi device types on
each channel monitored by a spectrum monitor.
show ap spectrum interference-power
Shows the interference power detected by a 802.11a or
80211g radio on a spectrum monitor.
show ap spectrum monitors
Shows a list of APs currently configured as spectrum
monitors.
show ap spectrum technical-support
Saves spectrum data for later analysis by your Dell
technical support representative.
Table 169: Spectrum Analysis CLI Commands