Users Guide

1747 | show ntp servers Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
delay Delay, in seconds, between the time that the local clock polls the NTP server and the NTP
server returns a reply.
offset The difference in time, in seconds, between the local clock and the NTP server.
disp Dispersion represents the maximum error of the local clock relative to the reference clock,
and is a measurement of the time server and network quality. Lower dispersion values are
preferred over higher dispersion values.
The following example shows the ntp servers configuration. The NTP server IP address, key ID and iburst
status are shown when the ntp servers brief command is used.
The following output is for IPv4:
(host) (config) #show ntp servers brief
server 1.1.1.1 key 1234
server 10.1.1.245 iburst key 12345
The following output is for IPv6:
(host) (config) #show ntp servers brief
server 2012::d63d:7eff:fe46:7309
Related Commands
To configure an NTP server, use the command ntp server.
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 6.1 The key-id parameter output displays when the ntp servers brief
command is used.
ArubaOS 6.4 Flags indicating the status of the server, were introduced.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on local and
master controllers