Users Guide

Parameter Description
user-capacity
Display the alert threshold for the controller’s user capacity. The output of this
command shows the percentage of the total resource capacity that must be
exceeded before the alert is sent.
The default threshold for this parameter is 80%.
Usage Guidelines
The controller will send a wlsxThresholdAbove SNMP trap and a syslog error message when the controller has
exceeded a set percentage of the total capacity for that resource. A wlsxThresholdBelow SNMP trap and error
message will be triggered if the resource usage drops below the threshold once again.
Example
(host) (config) #show threshold all
Controller Capacity Threshold Values
------------------------------------
RESOURCE THRESHOLD(%)
-------- ------------
Datapath-Cpu 30 %
Controlpath-Cpu 80 %
Controlpath-Memory 85 %
Total-Tunnel-Capacity 80 %
Ap-Tunnel-Capacity 80 %
User-Capacity 80 %
No-of-APs 80 %
No-of-locals 80 %
Command History
The command was introduced in ArubaOS 6.2.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master
and local controllers
Dell Networking W-Series ArubaOS 6.4.x | User Guide show threshold | 1912