Users Guide

mobility-manager
mobility-manager <ipaddr> user <username> <password> [interval <secs>]
[retrycount <number>] [udp-port <port>] [rtls <rtls-udp-port>] trap-version {1|2c|3}
Description
This command allows the controller to communicate with an MMS server.
Usage Guidelines
This command needs to be configured before the controller can communicate with the MMS server. This
command performs three tasks:
l Configures the IP address of the MMS server. In previous ArubaOS releases, this was done with the mobility-
server command.
l Creates an SNMP version 3 user profile with the configured <username> and <password>. This allows
SNMP SETs from the MMS server to be received by the controller. The authentication protocol is Secure
Hash Algorithm (SHA) and Data Encryption Standard (DES) is used for encryption. If <username> and
<password> match an existing SNMP v3 user profile, the existing one is used. Otherwise, a new profile is
created.
This username and password must be used when adding this controller to the MMS server in the MMS
Dashboard.
l Allows SNMP traps and notifications to be sent to the MMS server IP address, by adding this MMS server as
a trap receiver.
l Optionally enables the MMS server to function as a Real Time Location System (RTLS) server to receive
location information via APs from RTLS tags or other devices.
Use the show mobility-manager command to check the current status of the configured MMS servers.
Example
The following command configures the IP address and SNMP user profile for the MMS server:
(host) (config)# mobility-manager 10.2.1.245 user mms-user my-password.
Command History
This command was introduced in ArubaOS 3.1.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.4.x | User Guide mobility-manager | 650