Users Guide

packet-capture
packet-capture
controlpath [interprocess {all|<ports>}] [other] [sysmsg{all|<opcodes>] [tcp
{all|<ports>}] [udp{all|<ports>]]
copy-to-flash {controlpath-pcap | datapath-pcap}
datapath {ipsec <peer-ip>} [wifi-client <mac-address> {decrypted | encrypted | all}]
destination [interface <slot/port>] [ip-address <ip-address>] [local-filesystem]
no
reset-pcap {controlpath-pcap | datapath-pcap}
Description
Use this command to enable or disable packet capturing and set packet capturing options for a single packet
capture session.
Syntax
Parameter Description Default
controlpath
Enables controlpath packet capture. Captured pack-
ets are stored in /var/log/oslog/filter.pcap.
NOTE: Only capture to local-filesystem is supported
for controlpath capture.
Disabled
interprocess
Enables or disables interprocess packet capturing. .
Specify up to ten comma-separated ports to cap-
ture; use all to sniff all ports. All CLI ports, which
are TCP, are always skipped.
Disabled
other
Enable or disable all other types of packets. Disabled
sysmsg
Enable or disable internal messaging packets.
Specify up to ten comma-separated opcodes to
capture; use all to sniff all opcodes. All CLI
ports, which are TCP, are always skipped.
Disabled
tcp
Enable or disable TCP packet capturing. Specify
up to ten comma-separated ports to capture; use
all to sniff all TCP ports. All CLI ports, which are
TCP, are always skipped.
Disabled
udp
Enable or disable UDP packet capturing. Specify
up to ten comma-separated ports to capture; use
all to sniff all UDP ports. All CLI ports, which are
TCP, are always skipped.
Disabled
copy-to-flash
Copies captured packets to the flash.
—
controlpath-pcap
Copies controlpath captures. They are saved as
controlpath-pcap.tar.gz.
—
Dell Networking W-Series ArubaOS 6.4.x | User Guide packet-capture | 666