Users Guide

rf event-thresholds-profile
rf event-thresholds-profile <profile>
bwr-high-wm <percent>
bwr-low-wm <percent>
clone <profile>
detect-frame-rate-anomalies
fer-high-wm <percent>
fer-low-wm <percent>
ffr-high-wm <percent>
ffr-low-wm <percent>
flsr-high-wm <percent>
flsr-low-wm <percent>
fnur-high-wm <percent>
fnur-low-wm <percent>
frer-high-wm <percent>
frer-low-wm <percent>
frr-high-wm <percent>
frr-low-wm <percent>
no ...
Description
This command configures the event thresholds profile.
Syntax
Parameter Description Range Default
<profile>
Name of this instance of the profile. The name
must be 1-63 characters.
— “default”
bwr-high-wm
If bandwidth in an AP exceeds this value, a
bandwidth exceeded condition exists. The
value represents the percentage of maximum
for a given radio. (For 802.11b, the maximum
bandwidth is 7 Mbps. For 802.11 a and g, the
maximum is 30 Mbps.) The recommended
value is 85%.
0-100 0%
bwr-low-wm
After a bandwidth exceeded condition exists,
the condition persists until bandwidth drops
below this value. The recommended value is
70%.
0-100 0%
clone
Name of an existing radio profile from which
parameter values are copied.
— —
detect-frame-
rate-anomalies
Enable or disables detection of frame rate
anomalies.
— disabled
Dell Networking W-Series ArubaOS 6.4.x | User Guide rf event-thresholds-profile | 776