Users Guide

show adp config
show adp config
Description
Show Aruba Discovery Protocol (ADP) configuration settings.
Syntax
No parameters.
Example
The following example shows that the controller has all default settings for ADP.
(host) #show adp config
ADP Configuration
-----------------
key value
--- -----
discovery enable
igmp-join enable
igmp-vlan 0
The output of this command includes the following parameters:
Parameter Description
discovery Dell APs send out periodic multicast and broadcast queries to locate the
master controller. If the APs are in the same broadcast domain as the
master controller and ADP is enabled on the controller, the controller
automatically responds to the APs’ queries with its IP address.
This command shows whether ADP is enabled or disabled on the
controller.
igmp-join Shows whether the controller has enabled or disabled the sending of
Internet Group Management Protocol (IGMP) join requests.
igmp-vlan ID of the VLAN to which IGMP reports are sent. If this value is set to 0, the
controller will use the default route VLAN used.
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master
controllers
Dell Networking W-Series ArubaOS 6.4.x | User Guide show adp config | 916