Manualshelf

Reference Guide

ManualsBrandsDell ManualsAccess PlatformsW-Series FIPS
11121314151617181920
9
Label Function Action Status
Flashing – Green Device booting, not ready
On – Green Device ready
ENET Ethernet Network Link
Status / Activity
Off Ethernet link unavailable
On – Amber 10/100Mbs Ethernet link
negotiated
On – Green 1000Mbs Ethernet link negotiated
Flashing Ethernet link activity
11b/g/n 2.4GHz Radio Status
Off 2.4GHz radio disabled
On – Amber 2.4GHz radio enabled in WLAN
mode
On – Green 2.4GHz radio enabled in 802.11n
mode
Flashing - Green 2.4GHz Air monitor or RF protect
sensor
11a/n 5GHz Radio Status
Off 5GHz radio disabled
On - Amber 5GHz radio enabled in WLAN
mode
On – Green 5GHz radio enabled in 802.11n
mode
Flashing - Green 5GHz Air monitor or RF protect
sensor
2.3 AP-104
This section introduces the Aruba AP-104 Wireless Access Point (AP) with FIPS 140-2 Level 2 validation.
It describes the purpose of the AP, its physical attributes, and its interfaces.
The Aruba AP-104 is a high-performance 802.11n (2x2:2) MIMO, dual-radio (concurrent 802.11a/n +
b/g/n) indoor wireless access point capable of delivering combined wireless data rates of up to 900Mbps.
This multi-function access point provides wireless LAN access, air monitoring, and wireless intrusion
detection and prevention over the 2.4-2.5GHz and 5GHz RF spectrum. The access points work in
conjunction with Aruba Mobility Controllers to deliver high-speed, secure user-centric network services in
education, enterprise, finance, government, healthcare, and retail applications.
2.3.1 Physical Description
The Aruba AP-104 Access Point is a multi-chip standalone cryptographic module consisting of hardware
and software, all contained in a hard plastic case. The module contains an 802.11 a/b/g/n transceiver and
supports external antennas through 4 x dual-band (RP-SMA) antenna interfaces for supporting external
antennas.
The plastic case physically encloses the complete set of hardware and software components and represents
the cryptographic boundary of the module.
The Access Point configuration validated during the cryptographic module testing included:
AP-104-F1