Service Manual
Table Of Contents
- Vostro 5625 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Real-Time Clock (RTC Reset)
- Recovering the operating system
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
5. Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system board.
6. Replace the three screws (M2.5x5) that secure the right display hinge to the palm-rest and keyboard assembly.
7. Replace the display cable to the routing guides on the palm-rest and keyboard assembly.
8. Connect the display cable to the connector on the system board.
9. Close the latch and replace the clear adhesive tape.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or 4-cell battery, whichever is applicable.
About this task
NOTE:
A RJ-45 Network Port assembly for the I/O board is required.
If you are replacing the I/O board, transfer the existing RJ-45 Network Port assembly to the replacement I/O board.
The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.
40
Removing and installing components