Service Manual
Table Of Contents
- Vostro 5625 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Real-Time Clock (RTC Reset)
- Recovering the operating system
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the memory module.
4. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever is applicable.
5. Remove the wireless card.
6. Remove the heatsink.
About this task
The following image(s) indicate the location of the system board and provides a visual representation of the removal procedure.
1. Display-cable connector
2. Power-cable connector
3. Keyboard backlight-cable connector
4. Keyboard-cable connector
5. Touchpad-cable connector
6. Battery-cable connector
7. Speaker-cable connector
8. System fan-cable connector
9. SSD-1 slot connector
10. I/O board-cable connector
48
Removing and installing components