Service Manual
Table Of Contents
- Vostro 5625 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Real-Time Clock (RTC Reset)
- Recovering the operating system
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
NOTE:
The palm-rest and keyboard assembly includes the following components:
● Palm rest
● Keyboard
● Wireless antenna (2)
Next steps
1. Install the touchpad.
2. Install the speakers.
3. Install the system board.
4. Install the power-adapter port.
5. Install the power button.
6. Install the I/O board.
7. Install the coin-cell battery.
8. Install the fan.
9. Install the display assembly.
10. Install the 3-cell battery or 4-cell battery, whichever is applicable.
11. Install the wireless card.
12. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever is applicable.
13. Install the memory module.
14. Install the base cover.
15. Follow the procedure in After working inside your computer.
Removing and installing components
57