WiFi Network card Quick Installiaton Guide Version 1.
WPER-116GN PRODUCT SPECIFICATION Model Name WPER-116GN Bus Interface PCI Express Form Factor Mini PCIe Frequency Band 2.4GHz~2.484GHz Chipset Solution Ralink RT3090 RF Chain 1 Transmitter and 1 Receiver Antenna Port 1 Main: TX0 ; RX0 Dimension Channel Number 30.00mm x 26.80mm x 3.3mm (+/- 0.15 mm) US : Ch 1 ~ Ch 11 802.11b mode EU : Ch 1 ~ Ch 13 Japan : Ch 1 ~ Ch 14 US : Ch 1 ~ Ch 11 802.
Contents 1. Package Contents........................................................................................................... 3 2. WiFi Network Card Installation ........................................................................................ 4 3. Connect to Wireless Access Point ..................................................................................
Copyright statement No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photocopying, recording, or otherwise without the prior writing of the publisher.
1.
2. WiFi Network Card Installation 1. Put wifi module onto the expansion Adapter of the platform. 2. If he following message appear on your computer, click ‘Cancel’. 3. Insert the Driver CD then wait for the Autorun prompt.
4. If Autorun does not work, please browse the CD content and double click the “Setup.exe”. 5. Click “Next” and then follow the instructions on the screen to continue the installation.
6
6. When you see this message, please click “Finish” to complete the driver installation process.
3. Connect to Wireless Access Point 1. After installation is complete, a small Ralink icon appears in the notifications area of the taskbar. You can double click it to maximize the RaUI dialog box. 2. When starting RaUI, the system will connect to the AP with best signal strength without setting a profile or matching a profile setting. When starting RaUI, it will issue a scan command to a WiFi network card. After two seconds, the AP list will be updated with the results of a BSS list scan.
3. You could follow the steps to connect to the AP which you want to connect (Example to Configure Connection with WPA2-PSK). a. Select the AP and click “Connect” icon . b. Authentication/Encryption function appears.
c. Select WPA2-PSK as the Authentication Type. Select TKIP or AES encryption. Enter the WPA Pre-Shared Key. d. Click "OK". Be careful, if the WPA Pre-Shared Key entered is not correct, you won’t be able to exchange any data frames, even though the AP can be connected.
4. At last, if you want to know more using method of RaUI, you could refer to the help file by click the question mark at the top right corner of RaUI to open it.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
requirement of the end product, which integrates this module. 20cm minimum distance has to be able to be maintained between the antenna and the users for the host this module is integrated into. Under such configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be satisfied. Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment.
Appendix 14
