Installation and Service Manual

Table 3. Features available on the rear of the system (continued)
Item Ports, panels, or slots Icon Description
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for 16 seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
button is enabled in the iDRAC setup.
● If the system stops responding during POST, press and hold
the system ID button (for more than five seconds) to enter
the BIOS progress mode.
7
VGA port Enables you to connect a display device to the system.
8 OCP NIC port N/A This port supports OCP 3.0. The NIC ports are integrated on the
OCP card which is connected to the system board.
9 USB 3.0 port This port is USB 3.0-compliant.
10 USB 2.0 port This port is USB 2.0-compliant.
11 iDRAC dedicated port
Enables you to remotely access iDRAC. For more information, see
the iDRAC User’s Guide at www.dell.com/poweredgemanuals.
12 NIC ports The NIC ports that are integrated on the system board provide
network connectivity. These NIC ports can also be shared with
iDRAC when iDRAC network settings are set to shared mode.
For more information about the ports, see the Dell EMC PowerEdge R450 Technical Specifications on the product
documentation page.
Dell EMC PowerEdge R450 system overview
11