Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R450 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge R450 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Air shroud
- Cooling fans
- Intrusion switch module
- Drives
- Optional optical drive
- Drive backplane
- Cable routing
- System memory
- Processor and heat sink module
- Expansion cards and expansion card risers
- Optional serial COM port
- Optional BOSS S1 card
- Optional OCP card
- Front mounting front PERC module
- System battery
- Optional internal USB card
- VGA module
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Table 20. Configuration 2: R1+R2c (continued)
Card type Slot priority Maximum number of cards
Marvell (OCP: 10 Gb) Integrated slot 1
Intel (OCP: 10 Gb) Integrated slot 1
Broadcom (OCP: 1 Gb) Integrated slot 1
Intel (OCP: 1 Gb) Integrated slot 1
Dell External PERC Adapter 3, 1 2
Dell BOSS S1 Module Integrated slot 1
Intel (PCIe SSD AIC) 3, 1 2
Samsung (PCIe SSD AIC) 3, 1 2
Table 21. Configuration 3: No Riser
Card type Slot priority Maximum number of cards
Broadcom (OCP: 25 Gb) Integrated slot 1
Intel (OCP: 25 Gb) Integrated slot 1
Marvell (OCP: 25 Gb) Integrated slot 1
Mellanox (OCP: 25 Gb) Integrated slot 1
SolarFlare (OCP: 25 Gb) Integrated slot 1
Broadcom (OCP: 10 Gb) Integrated slot 1
Intel (OCP: 10 Gb) Integrated slot 1
Marvell (OCP: 10 Gb) Integrated slot 1
Broadcom (OCP: 1 Gb) Integrated slot 1
Intel (OCP: 1 Gb) Integrated slot 1
Dell BOSS S1 Module Integrated slot 1
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
Steps
1. For Riser 1, hold the blue touch points, and lift the expansion card riser from the riser connector on the system board.
66
Installing and removing system components