Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R450 Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge R450 system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Air shroud
- Cooling fans
- Intrusion switch module
- Drives
- Optional optical drive
- Drive backplane
- Cable routing
- System memory
- Processor and heat sink module
- Expansion cards and expansion card risers
- Optional serial COM port
- Optional BOSS S1 card
- Optional OCP card
- Front mounting front PERC module
- System battery
- Optional internal USB card
- VGA module
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 78. Removing the M.2 BOSS card from the M.2 BOSS riser
Next steps
If applicable, install a BOSS card into the M.2 BOSS riser.
Installing the M2 BOSS card into the M.2 BOSS riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Removing the M.2 BOSS riser.
Steps
1. Align and insert the M.2 BOSS card connector with the connectors on the M.2 BOSS riser.
2. Press the blue touch point on the M.2 BOSS card until it is firmly seated.
Figure 79. Installing the M2 BOSS card into the M.2 BOSS riser
78
Installing and removing system components