Setup Guide
CCM server is https://us1.cloudclientmanager.com and default
MQTT server is us1-pns.cloudclientmanager.com.
Override — Default is no. Yes/no option to allow a groupkey from
the INI le to override the previous groupkey. If Override=yes is
specied, the groupkey from the INI le will override the previous
groupkey. The Groupkey can technically be applied in many places.
You can congure the group key in order of priority, that is, if #1 is
dened it will override #2. Groupkey priority policy is listed below:
1 Local GUI conguration or groupkey received from CCM in a
Group Change command
2 Dened in INI le "ccmenable=yes groupkey=xxxx"
3 DHCP Option Tag #199
NOTE:
The Groupkey assigned in DCHP option #199 and INI
parameter are only used for rst time deployment, that is,
they only take eect if CCM is currently disabled or if CCM
is enabled but group-key is NULL.
If DCHP is dened and CCM is enabled or not NULL: The
CCM Group key in the DHCP is ignored since it is congured
manually in local UI or from CCM group change.
If INI is dened and CCM is enabled or not NULL: The CCM
Group key in the INI is ignored since it is congured manually
in local UI or from CCM group change.
IMPORTANT:
There is an exception in the logic above when the
'override=yes' option is used in INI le. This will make #2 take
priority over #1.
For example,
CCMEnable=yes CCMServer=xxx:8080
GroupPrefix=wlab GroupKey=TC-TEST-ENG
MQTTServer=xxx:1883 AdvancedConfig=yes
Override=yes
NOTE:
For detailed instructions on how to congure CCM in a
wnos.ini le to enable the CCM Agent on supported ThinOS
clients, refer to Knowledge Base Solution #23875, go to the
Knowledge Base at www.dell.com/wyse/knowledgebase and
search for 23875.
CAValidation—If the option is set to yes, then the CCM agent will
check the certicate when connected to https server. Default value
is yes.
Discover— If the option is set to yes, then the CCM agent will
discover the CCM server, MQTT server and CA validation from
DNS Record. Default value is yes.
IgnoreMqtt—If IgnoreMqtt=yes is specied, CCM agent will not
connect to MQTT server. Default value is no.
DefaultUser={username, $SYS_VAR}
[Display={yes, no}]
[disable={yes/no}]
Species the default sign-on user. See System Variables for a list of
system variables for $SYS_VAR.
16 Parameters for wnos INI les only