Setup Guide
[SecurityMode={Default,Low,Warning,Full}]
[EnableVWGateway]={yes, no}
[VWGateway]=url
[ConnectionType]={Default, All, RDP, PCoIP, Blast}
[EnableVDMCredSSP]={yes, no}
[RDCollections={*collect1, collect2,...}]
[DisableShowDisclaimer=[yes, no]
[DisableShowServer=[yes,no]
AWS is Amazon Workspace broker. It is only available with PCoIP
build.
IgnoreProle — Default value is no.
Set IgnoreProle=yes to disable parsing the global setting from the
VDI broker. It is only valid in the case of ConnectionBroker=default.
SecurityMode — SecurityMode species the security mode for
the VMware broker and Amazon Workspace (AWS) broker. It is only
valid in case of ConnectionBroker=VMware or
ConnectionBroker=AWS. The details is as follows:
• Set SecurityMode=Full to have the Client verify the server's
certicate in highest security mode; if any relevant checks error,
it will fail to connect to the server.
• Set SecurityMode=Warning to have the Client allow connection
continuation in the following two specic exceptions where full
verication would fail:
a Certicate is self-signed.
b Certicate has an invalid time.
• Set SecurityMode=Low to indicate that Client allows
connection without any certicate verication.
• Set SecurityMode=Default to indicate that Client follows the
SecurityPolicy setting to verify the certicate.
NOTE
:
For Dell vWorkspace broker, ConnectionBroker=Quest is
recommended.
EnableVWGateway and VWGateway are used to set the
vWorkspace gateway.
For VMware broker, ConnectionBroker=VMware is
recommended. ConnectionBroker=VDM is still supported but
deprecated.
The option ConnectionType species the display protocol that you
want to use when launching a session in VMware broker. If this
parameter is set, then the desktops that meet the specied
protocol are listed after broker sign on.
This setting is only valid in case of PCoIP feature is supported.
• Set ConnectionType=Default, only the desktops with the
default protocol congured in broker server are listed (this is the
default value for this setting).
• If you set ConnectionType=All, both PCoIP and RDP desktops
are listed.
• If you set ConnectionType=RDP, only RDP desktops are listed.
• If you set ConnectionType=PCoIP, only PCoIP desktops are
listed.
• If you set ConnectionType=Blast, only Blast desktops are listed.
EnableVDMCredSSP=yes—The option is set to yes to enable RDP
NLA mode connection when the VMware View broker session is
launched. The default value is no. EnableVDMCredSSP=yes works
only after you disable view security tunnel in server side.
RDCollections—The option species the collections for Microsoft
RD broker. Only the applications and desktops within the specied
collections are displayed. The value can be a list separated by ',' or ';'
and can use wildcard "*" to match the string. If the parameter is
22
Parameters for wnos INI les only