Setup Guide

Discover— If Discover=yes is specied, rapport discovers the
WDM server information from the DHCP option tag, DNS service
location record and DNS host name. If the WDM server is
discovered, the WDM server User Interface (UI) is protected on
device. The default value is yes.
SecurityMode species the SSL certication validation policy.
If set to default, it will apply SecurityPolicy setting.
If set to full, the SSL connection needs to verify server certicate.
If it is untrusted, then drop the connection.
If set to warning, the SSL connection needs to verify server
certicate. If it is untrusted, it's up to you to continue or drop the
connection.
If set to low, the server certicate is not checked. The value is
persistent, and the default value of the setting is default. If the
settings are factory default, or if you are upgrading to ThinOS 8.3
for the rst time, the value is temporarily set to low. After loading
any INI, it goes to default value.
WDMServer=<server_list>
[Retry=<retry number value>]
WDMServer — Species a list of IP addresses or DNS names
separated by using a comma for the WDM servers. Once specied,
it is saved in non-volatile memory.
Retry — Determines the number of attempts to retry a contact to
WDM servers.
WINSServer=server_list
Species the WINS server address. The WINSserver is an IP list
separated by ";" or ",", with a maximum list size of 2.
AutoSelectSingleCert={yes, no} When HTTPS is congured to verify client certicate, one window
pops up for user to select the client certicate. If only one client
certicate is available, set AutoSelectSingleCert=yes does not
prompt the window and automatically select the client certicate.
Parameters for wnos INI les only 43