Setup Guide

LpdSpool={0-50} Species the size of spool to buer all the data before sending
them to the LPD printer. The range of value is 0 to 10, that is, 0 MB
to 10 MB. If the specied value is above the range, then the value is
set to 5.
The range of value is extended to 50.
In build 8.2_001 or later builds, the LPD data is spooled to a le in a
ram disk instead of a buer. So the value of the parameter will not
be related to the spool size as before.
If LpdSpool=0, the function is disabled, otherwise the function is
enabled.
LPTPortBind={yes, no}
LPTPortBind — Default is Yes. Species the LPT bind to the USB
Port Policy.
If set to Yes, then the registered port follows the following binding
policy: LPT1 from USB ports 1/3/5/7 and LPT2 from USB posts
2/4/6.
If set to No, then the LPT port plugged in rst is LPT1 followed by
LPT2, and so on.
MicBoost={no, yes}
Default is no.
Yes/no option to enable on-board microphone boost.
**MouseNewSpeed={1-9}
Default is 6.
Value species the mouse speed within a range of 1 through 9,
where 1 is slowest and 9 is fastest. This parameter is the
replacement of MouseSpeed from build 7.0.1_07.
**MouseSwap={0, 1}
0/1 option to swap the mouse buttons. For example, for left-
handed use.
0 — No
1 — Yes
NetworkPrinter=host/queue
[PrinterID=Window driver name]
[Enabled={no, yes}]
NetworkPrinter — Species the conguration for the network
(LPD) printer in the same way as described for the Printer Setup
dialog box in the Dell Wyse ThinOS Administrator’s Guide. The host
and queue parameters dene the IP address and queue name of
the printer.
PrinterID — Species the Windows printer driver name.
Enabled — Default is yes. Yes/no option to enable the network
(LPD) printer.
Printer={COM1, COM2, LPT1, LPT2}
[Name=<name>]
[PrinterID=window_driver]
[Class=classname]
[Enabled={no, yes}]
[EnableLPD={no, yes}]
Default is COM1.
Printer — Species the local printer to congure.
Name — Species the name of the printer. This option must be
used.
PrinterID — If not specied, the default Generic/Text Only is used.
Class — Used in ThinPrint print for TPAutoconnect; the ThinPrint
technology of mapping the printer from the client side. It can group
printers to use the same template on the ThinPrint server side. The
Parameters for wnos INI, {username} INI, and $MAC INI les 65