Setup Guide
Enabled — Default is yes . Yes/no option to enable the printer.
EnableLPD — Default is no. Yes/no option to enable the LPD
printer.
Username — Species the username of a user who can use the
SMB printer.
Password — Species the password of a user who can use the
SMB printer.
Domain — Species the domain name of the SMB printer.
**RepeatDelay={0, 1, 2, 3, 4, 5, 6, 7}
Default is 2. Species the keyboard delay before repeat in seconds.
0 — 1/5
1 — 1/4
2 — 1/3
3 — 1/2
4 — 3/4
5 — 1
6 — 2
7 — No Repeat
**RepeatRate={0, 1, 2}
Default is 1. Species the keyboard repeat rate.
0 — Slow
1 — Medium
2 — Fast
*Resolution=[DDC, 640X480, 800X600,
1024X768, 1152X864, 1280X720,
1280X768, 1280X1024, 1360X768,
1366X768, 1368X768, 1400X1050,
1440X900, 1600X900, 1600X1200,
1680X1050, 1920X1080, 1920X1200]
[Refresh=60, 75, 85}
[rotate={right}]
Default is DDC.
Resolution — Species the local display resolution. Option DDC
can be specied to select default display resolution.
NOTE:
When using the Wyse Y Cable, DDC will properly work on
both monitors by default. However, if connected to R10L/
R00x clients and you are using Dual DVI, then you must add
the following DualHead INI parameter and DualHead option
for DDC to properly work on both monitors:
Parameter: DualHead=yes
Option: ManualOverride=yes
Refresh — Species the local display refresh rate.
NOTE:
If the Resolution or Refresh parameter values are changed,
the thin client will reboot without notice to the user.
Parameters for wnos INI, {username} INI, and $MAC INI les 67