Administrator Guide
Conguring the Camera Settings
Use the Camera tab to interface with cameras that are locally connected to the zero client (USB) and supported by a UVC driver. When
using the HDX RealTime webcam feature of Citrix Virtual Apps and Desktops, you can control options such as maximum resolution and
frames per second (10 FPS is recommended).
By default, the format of USB camera is set to RAW.
Figure 115. Peripherals—Camera
NOTE
:
You can optimize performance and modify the frame rate per second, if the Optimize for CPU check box is NOT selected—supported
values include 1/1, 1/2, 1/3, 1/4, 1/5, and 1/6 – directly from the zero client (if the webcam supports Universal Video Driver).
This feature is CPU intensive and is recommended for high performance products such as Wyse 5010 zero client for Citrix (D00DX).
Conguring the Touch Screen Settings
Use the Touch Screen tab to congure touch screens that are connected to the zero client. The tab is available (not grayed out) when the
zero client detects that a touch screen is attached through a USB port or a serial port and the setup or calibration has not been performed.
The Touch Setup window prompts you to touch two circles on the screen to make the necessary calibration adjustment. The adjusted
calibrated values are saved in the local terminal NVRAM until the system is reset to factory default, or another type of touch monitor is
connected.
130
Conguring Zero Client Settings