Administrator Guide

If you enter a delimited list of servers, the zero client will attempt to connect to the next server on the list, if the previous server
attempt fails. If you use the list and the selected connection fails, the zero client will attempt to connect to the next one on the
list.
NOTE: The hostname may be resolved using one of three mechanisms: ICA master browser, DNS, or WINS.
Master browser is the only mechanism that can resolve a published application unless manual entry is made
in DNS for the application. DNS uses the default domain name in the network control panel to attempt to
construct an FQDN but also tries to resolve the name without using the default.
e Encryption Level—Allows you to select the security level of communications between the zero client and the ICA server.
Basic (the default option) is the lowest level of security. Basic allows faster communication between the device and the ICA
server, because it requires less processing than the higher levels of encryption.
NOTE: The encryption selection applies to the security of communications between the zero client and the
ICA server only. It is independent of the security settings of individual applications on the ICA server. For
example, most web nancial transactions require the zero client to use 128-bit encryption. However,
transaction information could be exposed to a lower level of security if the zero client encryption is not also
set to 128-bits.
f Use HTTP for browsing—When this option is selected, by default the zero client uses HTTP when browsing.
g Alternate address via rewall—When selected, the zero client uses an alternate IP address that is returned from the ICA master
browser to get through rewalls. This is used for the Windows login when the connection is activated.
h Display Resolution—Select the display resolution for this connection. Only Default option is available.
i Colors—Only True Colors option is available for Wyse 5010 zero client for Citrix (D00DX).
j Autoconnect on start-up—When selected, automatically connects the session on start-up.
k Reconnect after disconnect—When this option is selected, the zero client automatically reconnects to a session after a non
operator-initiated disconnect. If selected, the wait interval is the time you set in the Delay before reconnecting box (enter the
number of seconds 1–3600). If there is no INI le congured for this connection, or if you are a stand-alone user, the default
value is set to 20 seconds.
3 Click the logon tab, and use the following guidelines:
Conguring
the connection broker 85