Administrator Guide
Table Of Contents
- Dell Wyse ThinOS Lite Release 2.6 Administrator’s Guide
- Introduction
- Before working on ThinOS Lite
- Getting started
- Global connection settings
- Configuring the connectivity
- Configuring the network settings
- Configuring the remote connections
- Configuring the Citrix broker setup
- Configuring the visual settings
- Configuring the general options
- Configuring the authentication settings
- Configuring the central configurations
- Configuring the VPN manager
- Configuring the connection broker
- Configuring Citrix
- Configuring the Citrix broker setup
- Citrix HDX RealTime Multimedia Engine—RTME
- Citrix Icon refresh
- Using multiple audio in Citrix session
- Using Citrix NetScaler with CensorNet MFA authentication
- Okta Integration through Citrix NetScaler
- Configuring ICA connections
- ICA Self Service Password Reset—SSPR
- QUMU or ICA Multimedia URL Redirection
- HTML5 Video Redirection
- ICA SuperCodec
- Anonymous logon
- Configuring the Citrix UPD Printer
- Introduction to Flash Redirection
- Configuring Citrix
- Configuring Zero Client Settings
- Performing Diagnostics
- BIOS Management
- Security Changes
- Creating and Using xen.ini Files
- Examples of Common Printing Configurations
- Important Notes
- Troubleshooting
Figure 111. Display—Dual Head
e. Swap dual screens—When you set Main Screen to Screen2, an additional check box is displayed at the bottom of the
tab offering to swap dual screens; If the check box is cleared, the Screen1 is usually the left one or the top one in dual
display. When you set Main Screen to Screen2 the main screen will be changed to the right screen or bottom screen; If
the check box swap dual screens is selected, you are able to set Main Screen to Screen2 but still have it at the left side
or the top side, which is considered more user friendly.
Changing display settings dynamically
From ThinOS Lite 2.4 release, after you change the display settings, the changes will take effect immediately without a system
restart.
Single Mode user scenario
Go to System Setup > Display > General and do the following:
1. Change resolution from DDC table or User defined display settings.
2. Change rotation setting from User defined display settings.
When the display settings are changed, the modified settings are applied to the active sessions dynamically. But some of the
active sessions disconnect and then reconnect.
Dual head user scenario
Configuring Zero Client Settings
117