Administrator Guide

Table 22. Parameters for a xen.ini File (continued)
Parameter Description
WDMFlash=flash_size The specified value will be saved into NVRAM, and then reports
to the WDM server. This statement ensures that all the units
would function with DDC regardless of flash size. This statement
is valid for all platforms and replaces the previous S10WDMFlash
statement.
WakeOnLAN={yes, no}
Default is yes.
Wake-on-LAN allows a ThinOS Lite to be turned on or woken up by
a network message.
If WakeOnLAN=yes, ThinOS Lite will respond for the Wake-On-LAN
packet for a remote wake up.
If WakeOnLAN=no, ThinOS Lite will not respond for the Wake-On-
LAN
NOTE: To use the WakeOnLAN parameter with a ThinOS Lite,
the ThinOS Lite must use BIOS version 1.0B_SPC001 or later.
WDAService=yes
[Priority ={WDM, WMS, “WDM;WMS”, “WMS;WDM”}]
[interval = {
0-65535}]
[disableNotice={yes, no}]
[disableCancel={yes, no}]
[noticeTime={0-255}]
[enableReminder={yes, no}]
WDA Service always runs in the background. If priority is available,
WDA discovers the protocol according to it.
Priority—There are only two protocols available now - WDM, and
Wyse Management Suite. For example, if priority=WDM; WDM,
WDA tries to discover the WDM server and tries to check-in, and if
it fails to check-in to WDM server, it tries to check-in the device to
Wyse Management Suite server.
interval—If interval is available, WDA rediscovery delay after a
failed check-in (both Wyse Management Suite and WDM failed)
is changed to interval minutes. The default value is 0. (WDA
rediscovery delay is 24 hours).
For example, if you set WDAService=yes interval=30, WDA
rediscovery delay is set as 30 minutes.
disableNotice—If disableNotice=yes, and the configuration from
WDM is received, the count down prompt window is not displayed.
The default value is no.
disableCancel—If disableCancel=yes, there is no possibility to
cancel count down prompt for WDM (device is going to reboot).
noticeTime—If noticeTime is available, the time of countdown
prompt is changed to time set using this parameter. Default
value is 20. For example, WDAService=yes disableNotice=no
disableCancel=yes noticeTime0
enableReminder—If enableReminder is set to yes, the reboot
warning window is displayed and the user has an option to postpone
the reboot. The default value is no.
Example: WDAService=yes enableReminder=yes
Whenever a reboot is required from Wyse Management Suite agent,
a warning dialog window is displayed. The user can postpone the
reboot for as many times set by the admin.
WDMService={
yes, no}
[DHCPinform={no, yes}]
[DNSLookup={no, yes}]
[QuickMode={yes, no}]
[Discover={
yes, no}]
The value is set to no, to disable the WDM agent. The default is yes.
Discovering the WDM server is supported by the following:
1. DHCP option tag values received from standard or WDM proxy
DHCP service for vendor class “RTIAgent”
2. .DNS service location record "_wdmserver._tcp"
216 Creating and Using xen.ini Files