Administrator Guide

Figure 24. Connection Settings - PCoIP
a. Enter the description for the PCoIP connection.
b. Enter the IP address of the remote host card.
c. From the Display Resolution drop-down list, select a display resolution for the PCoIP connection.
TERA2220 supports a single display with 2560 x 1600 resolution or two displays with 1920 x 1200 resolution. TERA2240
supports two displays with 2560 x 1600 resolution or four displays with 1920 x 1200 resolution.
d. Select either the Window mode or Full screen to set the initial view of the session.
e. If you want to automatically connect to the session after you restart the thin client, select the Auto-connect on
start-up check box.
f. Select the Re-connect after disconnect check box if you want to automatically reconnect to a session after the
session is disconnected. If you select this option, enter the wait interval in the Delay before re-connecting box. The
default is 20 seconds.
4. Click OK to save the settings.
For more information about the supported platforms and limitations, see the Dell Wyse ThinOS 8.6 Version Release Notes at
www.dell.com/support.
For information about the Teradici host cards, see the Host Card documentation at www.teradici.com.
Customize PCoIP login window and icons
You can create customized PCoIP icons for the PCoIP login window on ThinOS using .png, .jpg, or .bmp files. This feature is
available for the following platforms:
● Wyse 3040 Thin Client with PCoIP
● Wyse 5010 Thin Client with PCoIP
● Wyse 5040 AIO Thin Client with PCoIP
● Wyse 5060 Thin Client with PCoIP
140
Configuring the connection brokers