Administrator Guide

By default, the WMS option is selected. Wyse Management Suite service automatically runs after the client boot up.
If the first discovery, for example, the Wyse Management Suite service is not successful, it seeks for the next priority, for
example, WDM service. This continues until a discovery is successful. If all discoveries fail, it is started again automatically
after a fixed time—24 hours.
From ThinOS 8.6_710 onwards, after the initial INI configurations are received from Wyse Management Suite, the options
DNSFileServerDiscover, WMSEnable, and DHCPOptionsRemap are disabled if they are not previously defined. These
options are enabled after a factory reset or you can use INI parameters to enable them. For more information about using INI
parameters, see Dell Wyse ThinOS Version 8.6 INI Reference Guide at www.dell.com/support.
a. Enable Wyse Management Suite (WMS)—Select the check box to enable the Wyse Management Suite to discover
your thin client.
b. DNS SRV record—Select this check box if you want the thin client to obtain the Wyse Management Suite values
through DNS server, and then try to register into the Wyse Management Suite server. By default, the check box is
selected. If the check box selection is canceled, the thin client cannot obtain the Wyse Management Suite values through
DNS server.
To create DNS records in DNS server, use the following information:
80
Configuring connectivity