Administrator Guide

● Start—Executes the tracert command.
● Stop—Terminates the tracert command and leaves the Trace Route dialog box open, so that you can read the
information posted in the data area.
The tracert utility traces the path from your thin client to a network host. The host parameter is either a valid hostname or
an IP address. The tracert utility sends out a packet of information three times to each device (routers and computers) in
the path and displays the round trip response times and identifying information in the message box.
7. Click the Telnet tab, and do the following:
Figure 44. Telnet
a. Enter the hostname.
b. Click Connect to connect to a remote host or device.
The Telnet window is displayed, and the troubleshooting window is closed automatically.
206
Performing diagnostics