Deployment Guide
Table Of Contents
- Dell Wyse ThinOS Version 8.5 Hotfix INI Reference Guide
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for wnos INI files only
- Parameters for wnos INI, {username} INI, and $MAC INI files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Table 6. Connection Settings: wnos.ini files only (continued)
Parameter Description
disable — Default is no. Yes/no option to disable the
services. Disable must follow the Service parameter.
Service=snmpd disable={no, yes}
[community=<snmp_community> [encrypt={yes, no}]]
[communityReadOnly=<snmp_community_read_only>
[encrypt={yes,
no}]]
[servers=server_list]
Default is no.
Service=snmpd disable — Yes/no option to disable the
snmpd service.
community — The option community is same as the
statement Community. encrypt option is same as that in the
statement community.
communityReadOnly— This option is to set community only
has snmp get and get_next privileges. The following encrypt
option is only for indicating, if value of communityReadOnly is
encrypted.
Servers —This option is set to limit the valid snmp
management site to the IP addresses in the server_list
parameter, which contains 1 to 4 IPv4 IP addresses currently.
If not, all the set IP addresses seen as valid.
Service=thinprint disable={
no, yes}
[port=<port number>]
[PkSize={0-64000}]
Default is no.
Service=thinprint disable — Yes/no option to disable the
thinprint service.
port — Same as the statement ThinPrintEnable={no, yes}
port=portnumber.
PkSize — Specifies the default packet size that will be sent
to the server when negotiating with the thinprint server.
The value 0 will rely on the server default setting, 64000 in
ThinPrint 7.6 and 32000 in previous ThinPrint versions.
ThinOS only allocates a buffer of 64K, so if the default packet
size of the server is above 64000, this setting must be set or
printing will fail.
Service=vncd disable={no, yes}
[servers=server_list]
[HttpPort=_http_port_]
[TcpPort=_tcp_port_]
Service=vncd disable—Yes/no option to disable the vncd
service, same as MaxVncd={0, 1}.
Default is no.
servers—Use the servers option to limit the valid vncd
client site to the IP addresses in the server_list parameter,
which contains IPv4 IP or IP range addresses, such as
192.168.1.0/24; 192.168.2.48.
If this option is not set, all IP addresses are displayed as valid.
The service vncd supports both http and tcp connections. The
option HttpPort enables you to set the http port for vncd
service. The default port is 5800.
The option TcpPort enables you to set the tcp port for vncd
service. The default port is 5900.
Service=wdm disable={no, yes}
Default is no.
Yes/no option to disable the WDM service, same as
RapportDisable={no, yes}.
Service=<port number> disable={no, yes}
Default is no.
Yes/no option to disable the service with this port number.
The 80 port is an exception because the WDM is always
started before loading the global profile (wnos.ini file).
Parameters for wnos INI files only 35