Setup Guide
Table Of Contents
- Dell Wyse ThinOS Version 8.6 INI Reference Guide
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for wnos INI files only
- Parameters for wnos INI, {username} INI, and $MAC INI files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Table 9. Connection Settings: wnos.ini files, {username} INI, and $MAC INI files (continued)
Parameter
* Global overrides identically-named user profile
** After sign off, user profile returns to global value
Description
[DisableResetVM={no, yes}]
[WyseVDAServerPort=serverPort]
[FontSmoothing={
yes, no}]
[AutoConnect={yes, no}]
[MultiMonitor={yes, no}]
[EnableImprivataVC={yes,no}]
[Locale=LocaleID]
[SessionLogoffTimeout=seconds]
[GroupSession={yes,no}]
1. The port range is a list of start port and end port
separated by a semicolon (;) or a comma (,).
2. Both ports must be between 1 and 65535.
3. The end port must be greater than start port.
For example, WyseVDA_PortRange=3000,3010, the start port
is 3000, the end port is 3010.
UnmapClipboard — Default is no. Yes/no option to disable
clipboard redirection for all sessions. For ICA and RDP,
specifies if redirecting the clipboard. This setting in wnos.ini
will be saved into nvram, if EnableLocal parameter is set to
yes in wnos.ini.
DefaultColor — Specifies the default color depth to use for
the session 0=256, 1=High color, 2=True Color.
VUSB_DISKS — Default value is yes.
VUSB_AUDIO, VUSB_VIDEO, and VUSB_PRINTER —
The default value is no. The options specifies if these USB
devices are redirected to the server using ICA or RDP USB
redirection. In addition, by default, these devices are set as
local devices.
NOTE: For example, if you want to use USB disks as a
network disk, you can set SessionConfig=all mapdisks=yes
VUSB_DISKS=no.
If you want to use USB disks as server side device, you
can set SessionConfig=all mapdisks=no
VUSB_DISKS=yes. The devices are displayed in device
manager of the session.
FullScreen — Default is no. Specifies the default screen
mode. When using FullScreen in a Dual Screen mode, the
session will be displayed in Span mode
Continued from the previous table...
Resolution — Default is default. Specifies the session
resolution. For example, 640 x 480 and other supported
resolutions.
Default will set the resolution to the native resolution of the
monitor. Setting the resolution to a value smaller than the
native resolution of the monitor, will allow the session in
Windowed mode. The resolution value cannot be higher than
the native resolution.
DisableResetVM — Default is no. Set DisableResetVM=yes
to disable Reset VM function. As default, this function is
controlled by the server side is enabled including VMware
View or Citrix PNA.
WyseVDAServerPort — Sets Wyse VDA Server Port for a
ThinOS VDA client. The default port is 3471. The port range
must be from 1029 to 40000. For example,
WyseVDAServerPort=3000, sets VDA server port to 3000 and
the client will connect to the VDA server using this port.
Parameters for wnos INI, {username} INI, and $MAC INI files 89