Administrator Guide

To congure the First Boot Wizard:
1. Connect a new thin client or existing thin client to the Ethernet using a wired connection. The existing thin client must be reset
to factory default settings to enter the First Boot Wizard.
2. Turn on your thin client.
The thin client checks for a wired network connection. If the network connection is successful, a welcome screen with the
model name of your thin client is displayed.
The thin client validates the IP address from DHCP. If the DHCP contains the le server or the Wyse Device Manager or Wyse
Management Suite congurations, then the ThinOS system desktop is loaded without entering the First Boot Wizard. If the
DHCP validation fails or if you have not connected to Ethernet, then follow the next step.
NOTE: To exit the First Boot Wizard during the network connection status check on the welcome screen, press the
Ctrl + Esc key.
3. On the Would you like to load a ThinOS conguration le from USB? screen, do either of the following:
• To load a ThinOS conguration le from the USB drive, ensure that you create a wnos.ini le and add the le to the /wnos
directory on the USB drive. Using this option, you can load packages, and wallpapers that are specied in the INI le. Plug in
the USB drive to thin client, and click Yes.
NOTE: Only FAT, FAT32, and ExFAT le systems on the USB disk are supported. NTFS le system is not
supported.
The thin client validates the conguration le in the USB drive.
– If the ThinOS conguration le in the USB drive is correct, the Read conguration success message is displayed. Click
OK to exit the First Boot Wizard, and log in to the ThinOS system desktop.
– If the ThinOS conguration le in the USB drive is corrupted or the appropriate le is not available, then the Cannot nd
conguration les, or read conguration failure message is displayed. Upload the correct le on the USB drive, plug
the USB drive again, and then click Retry. If the le is correct, the Read conguration success message is displayed.
Click OK to exit the First Boot Wizard, and log in to the ThinOS system desktop.
If you do not want to use the Retry option to load the ThinOS conguration le, then click Abort to enter the System
Preferences conguration setup.
NOTE: To exit the Cannot nd conguration les, or read conguration failure message screen, and load the
ThinOS system desktop, click Exit.
• To enter the System Preferences conguration setup, click No.
4. On the System Preferences Conguration screen, congure the following options:
12