Deployment Guide

Table 6. Connection Settings: wnos.ini files only (continued)
Parameter Description
including the trailing period and the file extension, is limited to
64 characters.
AddCertificate must be used when configuring the Citrix
Secure Gateway PNAgent Interface (PNAgent/Lite servers)
in the Network Setup dialog box.
Adding certificates are required if the user CSG environments
use certificate agents that are not covered by the built-
in certificates. The certificates are used to validate server
identities by the thin client. Supported files include .crt file on
ICA CSG; .cer and .pfx in 802.1x. Password and Password-Enc
are specially used with PFX files.
CaradigmServer=vip list
[EGPGroup=group name]
[EnableLogOff={yes,no}]
[SecurityMode={
default, full, warning, low}]
[DisableManualLogon=yes, no]
CaradigmServer=vip list contains a list of VIP addresses with
optional TCP port number of Caradigm servers. EGPGroup
defines the user group name. If EnableLogOff=yes is
specified, the user is logged off from the session before
system signs off. Otherwise the session is disconnected. The
logged off user has a timeout value which can be set using
SessionConfig parameter SessionLogOffTimeout.
The default timeout value is 1, if no SessionLogOffTimeout is
specified.
SecurityMode specifies the SSL certification validation policy.
If set to default, it applies the SecurityPolicy setting.
If set to full, the SSL connection needs to verify server
certificate. If it is untrusted, drop the connection.
If set to warning, the SSL connection needs to verify server
certificate.
If it is untrusted, it is up to you to continue or drop the
connection.
If set to low, the server certificate is not checked. The value is
persistent, the default value of the setting is default.
DisableManualLogon is set to yes to disable user to manually
enter credentials to authenticate into the device. It only allows
an already enrolled proximity badge and in active grace period
to authenticate with a single badge tap. The default value is
no
Community=community
[Encrypt={yes, no}]
Specifies the SNMP community name. A string up to 31
characters are allowed. After the value is specified, it is saved
in the non-volatile memory.
If encrypt=yes, an encrypted string is used as a community
name.
The default value is set to no.
NOTE: Use our Windows Password_Gen tool or built-in
tool to generate the encrypted string.
ConnectionBroker={default, VMware, Microsoft, Quest, AWS}
[IgnoreProfile={yes, no,}]
[SecurityMode={Default,Low,Warning,Full}]
[EnableVWGateway]={yes, no}
[VWGateway]=url
Default value is default. Specifies the type of VDI broker to
use. Default is a 3rd party VDI broker.
AWS is Amazon Workspace broker. It is only available with
PCoIP build.
IgnoreProfile — Default value is no.
Parameters for wnos INI files only 19