Deployment Guide

Table 6. Connection Settings: wnos.ini files only (continued)
Parameter Description
[ConnectionType]={Default, All, RDP, PCoIP, Blast}
[EnableVDMCredSSP]={yes, no}
[RDCollections={*collect1, collect2,...}]
[DisableShowDisclaimer=[yes,
no]
[DisableShowServer=[yes,no]
[EnableUnauthenticatedAccess]={yes,no}
[Host={broker_url}]
[AutoConnectList={*|host1;host2;host3...}]
Set IgnoreProfile=yes to disable parsing the global setting
from the VDI broker. It is only valid in the case of
ConnectionBroker=default.
SecurityMode — SecurityMode specifies the security mode
for the VMware broker and Amazon Workspace (AWS)
broker. It is only valid in case of ConnectionBroker=VMware
or ConnectionBroker=AWS. The details is as follows:
● Set SecurityMode=Full to have the Client verify the
server's certificate in highest security mode; if any
relevant checks error, it will fail to connect to the server.
● Set SecurityMode=Warning to have the Client allow
connection continuation in the following two specific
exceptions where full verification would fail:
1. Certificate is self-signed.
2. Certificate has an invalid time.
● Set SecurityMode=Low to indicate that Client allows
connection without any certificate verification.
● Set SecurityMode=Default to indicate that Client follows
the SecurityPolicy setting to verify the certificate.
NOTE:
For Dell vWorkspace broker, ConnectionBroker=Quest is
recommended.
EnableVWGateway and VWGateway are used to set the
vWorkspace gateway.
For VMware broker, ConnectionBroker=VMware is
recommended. ConnectionBroker=VDM is still supported
but deprecated.
The option ConnectionType specifies the display protocol that
you want to use when launching a session in VMware broker.
If this parameter is set, then the desktops that meet the
specified protocol are listed after broker sign on.
This setting is only valid in case of PCoIP feature is supported.
● Set ConnectionType=Default, only the desktops with the
default protocol configured in broker server are listed (this
is the default value for this setting).
● If you set ConnectionType=All, both PCoIP and RDP
desktops are listed.
● If you set ConnectionType=RDP, only RDP desktops are
listed.
● If you set ConnectionType=PCoIP, only PCoIP desktops
are listed.
● If you set ConnectionType=Blast, only Blast desktops are
listed.
EnableVDMCredSSP=yes—The option is set to yes to
enable RDP NLA mode connection when the VMware
View broker session is launched. The default value is no.
EnableVDMCredSSP=yes works only after you disable view
security tunnel in server side.
20
Parameters for wnos INI files only