Deployment Guide

Table 6. Connection Settings: wnos.ini files only (continued)
Parameter Description
If EnableRAVE=no or this parameter is not present,
the TCX Multimedia will be used for all media files. If
EnableRAVE=yes, RAVE will be used only for media files
it supports.
EnableRAVE=yes is ignored unless a valid TCX Multimedia
license is used.
FileServer=List of {IP address, DNS name}
[Username=username]
[Password=password]
[SecurityMode={Low, Warning, Full,
default}]
[Username-Enc={encrypted_password_string}]
[Password-Enc={encrypted_password_string}]
FileServer — Specifies the FTP or Web (http://) server IP
address or DNS name that is entered into thin client local
setup (non-volatile memory); the thin client immediately uses
this server to access files.
Username — Specifies the username of the file server.
Password — Specifies the password of the file server.
NOTE:
The target file server must support access using the same
user credentials used in the INI files.
The optional keyword Username and Password specify the
username/password of the file server. When the client
fetches the WNOS.INI file from a HTTPS server, ThinOS
supports different security modes. The default follows
SecurityPolicy and may be one of the three modes. The option
SecurityMode specifies these security modes.
SecurityMode — Specifies the security level for the file
server during client verification of the server certificate. This
option is only valid when connecting to an https file server.
When configuring the https file server, the Username and
Password options of the FileServer parameter can be omitted.
Use the following guidelines:
● Set SecurityMode=Full to have the client verify the server
certificate in highest security mode; if any error occurs
during verification, the client will not connect to the server
and a pop-up message is displayed.
● Set SecurityMode=Warning to have the client provide
a warning when the client cannot verify the server
certificate, but still allow the user to select to continue
client connection to the server.
● Set SecurityMode=Low to indicate that the client allows
connection without any certificate verification.
● Set SecurityMode=Default to indicate that the client
follows SecurityPolicy settings to check certificate.
● Default value of the setting is Default. If the settings are
factory default or if you are upgrading to ThinOS 8.3 for
the first time, the value is temporarily set to None. After
loading any INI, it goes to default.
● If the security mode value in WNOS.INI is not the same
as the one saved in Client NVRAM, client shows a reboot
dialog box.
NOTE:
Security process includes:
1. Verification that certificate has a valid date
2. Verification that Issuer is valid and correct
Parameters for wnos INI files only 25