Setup Guide

[Priority ={WDM, CCM, “WDM;CCM”, “CCM;WDM”}]
[disableNotice={yes, no}]
[disableCancel={yes, no}]
[noticeTime={0-255}]
[interval = {0-65535}]
Priority—If priority is available, WDA discovers the protocol
according to it.
There are only two protocols available now - WDM, and CCM. For
example, if priority=WDM; CCM, WDA tries to discover WDM
server and tries to check-in, and if it fails to check-in to WDM
server, it tries to check-in the device to CCM server.
disableNotice—If option is set to yes, count down prompt will not
show when conguration from WDM is received. Default is no.
disableCancel—If set to yes, there is no possibility to cancel count
down prompt for WDM (device is going to reboot). Default is no.
noticeTime—If this is set, then the time of countdown prompt is
changed to seconds. Default is 20 seconds.
Examples: WDAService=yes disableNotice=no disableCancel=yes
noticeTime=0. In this scenario, count down prompt is displayed if
WDM conguration is received, but you are not allowed to cancel
system reboot, and amount time of count down prompt is set to
default value (20 seconds).
interval—If interval is available, WDA rediscovery is delayed after
check-in fails (both CCM and WDM fails). This delay is changed to
interval minutes. Default is 0. (WDA rediscovery delay is 24 hours).
Example: WDAService=yes interval=30
WDA rediscovery delay is set as 30 minutes.
WDMFlash=ash_size
The specied value will be saved into NVRAM, and then reports to
the WDM server. This statement ensures that all the units would
function with DDC regardless of ash size.
This statement is valid for all platforms and replaces the previous
S10 WDM Flash statement.
WDMService={yes, no}
[DHCPinform={no, yes}]
[DNSLookup={no, yes}]
[QuickMode={yes, no}]
[Discover={yes, no}]
[SecurityMode={default, full, warning, low}]
Default is yes.
WDMService — Yes/no option to disable the WDM agent.
Discovering the WDM server is supported by the following:
1 DNS host name lookup wdmserver
2 DNS service location record _wdmserver._tcp
3 DHCP option tag values received from standard or WDM
proxy DHCP service for vendor class RTIAgent
DHCPinform — Default is no. Yes/no option to use DHCP
information.
DNSLookup — Default is no. Yes/no option to use DNSLookup.
For Example: If WDMService=yes, setting DHCPinform=yes will do
number 3, setting DNSLookup=yes will do numbers 1 and 2.
If QuickMode=yes is specied, rapport agent will not block any
other process during ThinOS boot up, and boot time of ThinOS will
speed up.
NOTE: If le server is changed by WDM server, device will
reboot automatically to make sure all settings from WDM
server take eect. Default is yes.
42 Parameters for wnos INI les only