Administrator Guide

1 Connect a new zero client or existing zero client to the Ethernet using a wired connection. The existing zero client must be reset to

factory default settings to enter First Boot Wizard.

2 Turn on your zero client.

The zero client checks for a wired network connection. If the network connection is successful, a welcome screen with the model

name of your zero client is displayed.

The zero client validates the IP address from DHCP. If the DHCP contains the le server or Wyse Device Manager or Wyse

Management Suite congurations, then the ThinOS Lite system desktop is loaded without entering First Boot Wizard. If the DHCP

validation fails or if you have not connected to Ethernet, then follow the next step.

NOTE: To exit First Boot Wizard during the network connection status check on the welcome screen, press the Ctrl +

Esc key.

3 On the Would you like to load a ThinOS Lite conguration le from USB? screen, do either of the following:

Figure 3. USB conguration

• To load a ThinOS Lite conguration le from the USB drive, ensure that you create a xen.ini le and add the le to the /xen

directory on the USB drive. Plug the USB drive to zero client, and click Yes.

NOTE

Only FAT, FAT32, and ExFAT le systems on the USB disk are supported. NTFS le system is not

supported.

The zero client validates the conguration le in the USB drive.

– If the ThinOS Lite conguration le in the USB drive is correct, the Read conguration success message is displayed. Click

OK to exit First Boot Wizard, and log in to ThinOS Lite system desktop.

– If the ThinOS Lite conguration le in the USB drive is corrupted or the required le is not available, then the Can not nd

conguration les, or read conguration failure message is displayed. Upload the correct le on the USB drive, plug the USB

drive again, and then click Retry. If the le is correct, the Read conguration success message is displayed. Click OK to exit

First Boot Wizard, and log in to ThinOS Lite system desktop.

If you do not want to use the Retry option to load the ThinOS Lite conguration le, then click Abort to enter the System

Preferences conguration setup.

NOTE

: To exit the Can not nd conguration les, or read conguration failure message screen, and load

the ThinOS Lite system desktop, click Exit.

• To enter the System Preferences conguration setup, click No.

4 On the System Preferences Conguration screen, congure the following options:

Getting started