Administrator Guide

Parameter Description
1280X768, 1280X1024, 1360X768,
1366X768, 1368X768, 1400X1050,
1440X900, 1600X900, 1600X1200,
1680X1050, 1920X1080, 1920X1200]
[Refresh=60, 75, 85}
[rotate={right}]
NOTE:
When using the Wyse Y Cable, DDC will properly work on both
monitors by default. However, if connected to R10L/R00x clients
and you are using Dual DVI, then you must add the following
DualHead INI parameter and DualHead option for DDC to properly
work on both monitors:
Parameter: DualHead=yes
Option: ManualOverride=yes
Refresh — Species the local display refresh rate.
NOTE:
If the Resolution or Refresh parameter values are changed, the
zero client will reboot without notice to the user.
rotate — Rotate allows you to rotate monitors for viewing in Portrait
mode. For example:
screen=1 resolution=1280x1024 refresh=60
rotate=none
NOTE:
Due to processing power requirements, rotate is not recommended
and supported on the C class platforms at this time.
IMPORTANT:
The Screen parameter must be placed before the Resolution
parameter. For example:
screen=1 resolution=1280x1024 refresh=60
rotate=none
RootPath=<le server root path>
This le server root path is entered into the zero client local setup (non-
volatile memory). The zero client immediately uses this path to access
les. The directory name \xen will be appended to the le server root
path entry before use.
**ScreenSaver=value{0, 1, 3, 5, 10, 15, 30}
[LockTerminal={0, 1, 2, 3}]
[Type={0, 1, 2, 3, 4}]
[VideoLink=httplink]
[VideoSpan=no]
[Unit=hour]
[Image=imagele]
[PictureTimer={2-60}]
[PictureOrder=random]
[PictureCheck=always]
[PictureLayout={stretch, tile, center}]
Screensaver— Species to put the thin client in a screensaver state
when the time limit for inactivity is reached, that is delay before starting is
reached.
Default value is 10. Value and delay before starting the screensaver:
0 — Disabled
1 — 1 Minute
3 — 3 Minutes
5 — 5 Minutes
10 — 10 Minutes
15 — 15 Minutes
30 — 30 Minutes
The default screen saver value is 10 minutes and the maximization value is
30 minutes.
214 Creating and Using xen.ini Files