Administrator Guide
b Interpret DHCP Vendor-Specic Info — Select this check box for automatic interpretation of the vendor information.
c DHCP Vendor ID — Shows the DHCP Vendor ID when the dynamically allocated over DHCP/ BOOTP option is selected.
d DHCP UserClass ID — Shows the DHCP UserClass ID when the dynamically allocated over DHCP/BOOTP option is selected.
3 Click OK to save the settings.
Conguring the ENET settings
To congure the ENET settings:
1 From the oating bar menu, click System Setup, and then click Network Setup.
The Network Setup dialog box is displayed.
2 Click the ENET tab, and use the following guidelines:
Figure 9. ENET settings
a Ethernet Speed — Normally the default (Auto-Detect) should be selected, but another selection can be made if automatic
negotiation is not supported by your network equipment. Selections include Auto-Detect, 10 MB Half-Duplex, 10 MB Full-
Duplex, 100 MB Half-Duplex, 100 MB Full-Duplex, and 1 GB Full-Duplex.
The 10 MB Full-Duplex option can be selected locally at the device, however, this mode may need to be negotiated through
AutoDetect.
b The IPV4 check box is selected by default. Click Properties to set various options supported by IPV4.
32
Conguring the connectivity