Setup Guide

Table 14. RDP connect options (continued)
TSGWUsername=[username] Specifies the TS Gateway Username for RDP session.
TSGWUsername-enc=[encrypted-username] Specifies the encrypted TS Gateway Username for RDP
session.
TSGWUSESAMEINFO={no, yes}
Default is no.
Yes/no option to apply RDP connection credential to Gateway
credential.
UniSession={no, yes}
Default is no.
Yes/no option to use a unisession—a connection will launch
only once at a time.
UnmapClipboard={no, yes}
Default is no.
Yes/no option to disable clipboard redirection for an RDP
session if redirecting the clipboard.
UnmapPrinters={no, yes}
Default is no.
Yes/no option to not auto-connect to local printers when the
connection.
UnmapSerials={no, yes}
Default is no.
Yes/no option to not auto-connect to local serials when the
connection.
UnmapUSB={no, yes}
Default is no.
Yes/no option to not auto-connect to local USB devices
(Virtual USB) when the connection starts.
Username=[username, $SYS_VAR]
Username to log-in to the application server. Either a
conventional login username or a variable can be used.
Maximum of 31 characters are allowed.
The value of username is a conventional log-on username.
The value of $SYS_VAR is a system variable found in Table:
System variables.
NOTE:
The combination of all the variables such as $IP@$DN are
also supported.
Username-enc=an encrypted username Specifies an encrypted string as a username for a connection.
[WyseVDA={no, yes}]
Default is no.
Yes/no option to enable Wyse Virtual Desktop Accelerator for
all RDP sessions.
100 Connect Parameter: Options